Stryker Power-PRO XT Manuel D'utilisation Et D'entretien page 55

UNLOADING THE COT FROM A VEHICLE WITH TWO OPERATORS - MANUAL METHOD (CONTINUED)
With one operator at the foot end and one on the side (Figure 44):
• Operator 1 − Grasp the cot frame at the foot end. Pull the manual back-up release handle to lower the
undercarriage to its fully extended position (Figure 45). Pull the cot out of the patient compartment until the
safety bar engages the safety hook.
• Operator 2 − Verify that the safety bar engages the safety hook.
• Operator 2 − Stabilize the cot during the unloading operation by securely grasping the outer rail.
Figure 44
4. Operator 2 − Pull the safety bar release lever forward
to disengage the safety bar from the safety hook in the
patient compartment (Figure 46).
5. Remove the load wheels from the patient compartment
of the vehicle.
CAUTION
When unloading the cot from the patient compartment,
ensure that the caster wheels are safely set on the ground
or damage to the product may occur.
www.stryker.com
Operation Guide
6506-109-005 REV F
Figure 45
Figure 46
Return To Table of Contents
English
1-47