Stryker Power-PRO XT Manuel D'utilisation Et D'entretien page 49

UNLOADING THE COT FROM A VEHICLE WITH TWO OPERATORS - POWERED METHOD (CONTINUED)
With one operator at the foot end and one on the side (Figure 32):
• Operator 1 − Grasp the cot frame at the foot end. Pull the cot out of the patient compartment until the safety
bar engages the safety hook.
• Operator 2 − Verify that the safety bar engages the safety hook.
• Operator 2 − Stabilize the cot during the unloading operation by securely grasping the outer rail.
• Operator 1 − Depress the extend (+) button to lower the undercarriage to its fully extended position as shown
in Figure 33.
Note: You can use the manual release or a combination of the manual release followed by the extend (+) button.
If the extend (+) button is used, you must ensure that the manual release is fully engaged before pressing the
extend (+) button.
Figure 32
4. Operator 2 − Pull the safety bar release lever forward
to disengage the safety bar from the safety hook in the
patient compartment as shown in Figure 34.
5. Remove the load wheels from the patient compartment
of the vehicle.
CAUTION
• When unloading the cot from the patient compartment,
ensure that the caster wheels are safely set on the
ground or damage to the product may occur.
• Do not "jog" the cot past the established cot load height
of the product when the safety bar engages the vehicle
safety hook or damage may occur to the product.
www.stryker.com
Operation Guide
6506-109-005 REV F
Figure 33
Figure 34
Return To Table of Contents
English
1-41