Siderail Assembly Replacement (Standard) - Stryker Power-Pro Xt Manuel D'utilisation Et D'entretien

SIDERAIL ASSEMBLY REPLACEMENT (STANDARD)

English
Tools Required:
• T25 Torx Driver
Procedure:
1. Raise the cot to the full upright position.
2. Raise the siderail to the up and locked position.
3. Using a T25 driver, remove the three spindle screws that secure the siderail assembly.
4. Remove the siderail.
5. Reverse the above procedures to install the new siderail assembly.
6. Verify proper operation of the unit before returning it to service.
Return To Table of Contents
1-112
Service Information
6506-109-005 REV F www.stryker.com