Child Restraint With X-Restraint Package Installation - Stryker Power-Pro Xt Manuel D'utilisation Et D'entretien

Child Restraint with X-Restraint Package Installation

To attach the Britax Meridian SICT Series No. 7200/A/2010
Convertible Child Restraint to the cot with the X-Restraint
English
package (6500-001-430):
1. Lay the cot flat.
2. Open the waist restraint strap. Lay the straps to the side
and out of the way.
3. Position the child restraint to face the foot end of the cot.
4. Place the child restraint into the reclined position.
5. Raise the cot fowler up to align with the back of the child
restraint.
6. Loop the upper anchorage strap with the anchor fitting
and attachment clip from the child restraint around the cot
fowler (Figure 122). Pull the adjustment strap to tighten and
remove slack.
7. Pull the waist restraint under the siderail and through the
bottom of the child restraint (Figure 123).
8. Firmly push down on the seat with your hand, while pulling
the waist restraint with the other hand to tighten the waist
restraint.
9. If your ankle restraint is long enough to reach the foot end
of the child restraint, pull the ankle restraint through the
foot end of the child restraint (Figure 124).
10. If your ankle restraint is too short to reach the foot end of
the child restraint:
• Remove the thigh restraint from your cot.
• Relocate the thigh restraint to the foot end lift bars
(Figure 125).
• Pull the thigh restraint through the foot end of the child
restraint (Figure 124).
11. Firmly push down on the seat with your hand, while pulling
the leg restraint with the other hand to tighten the leg
restraint.
12. While holding the tension, close the rear facing lock-off on
the buckle side to hold the tension (Figure 126).
13. Close the rear facing lock-off on the opposite side.
14. Place the baby into the child restraint and secure per
manufacturer's instructions.
Return To Table of Contents
1-116
Figure 125
6506-109-005 REV F
Figure 122
Figure 123
Figure 124
Figure 126
www.stryker.com