Stryker Power-PRO XT Manuel D'utilisation Et D'entretien page 19

SPECIFICATIONS (CONTINUED)
Environmental Conditions
Temperature
Relative Humidity
Atmospheric Pressure
Stryker reserves the right to change specifications without notice.
The Power-PRO™ XT is designed to conform to the Federal Specification for the Star-of-Life Ambulance (KKK-A-1822).
The Power-PRO™ XT is designed to be compatible with competitive cot fastener systems.
Patents pending.
The yellow and black color scheme is a proprietary trademark of Stryker Corporation.
Stryker hereby declares that this Power-PRO™ XT ambulance cot (model 6506) is in compliance with the essential
requirements and other relevant provisions of Directive 1999/5/EC. A copy of the original declaration of conformity
can be obtained by contacting Stryker Medical at 3800 E. Centre Ave. Portage, MI 49002 Attn. Regulatory Affairs.
CAUTION
• Changes or modifications to the unit not expressly approved by Stryker could void the user's authority to operate
the system.
• This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at their expense.
www.stryker.com
Introduction
Operation
130 °F
(54 °C)
-30 °F
(-34 °C)
93%
0%
1060 hPa
700
6506-109-005 REV F
Storage and Transportation
130 °F
(54 °C)
-30 °F
(-34 °C)
93%
0%
1060 hPa
700
Return To Table of Contents
1-11
English