VEVOR YML03110F Mode D'emploi page 9

• Periodically change water to prevent water from becoming sticky and forming
microorganisms.
Trouble Shooting
If the pump fails to run, the following should be checked:
• Check the circuit breaker, or try a different outlet to make sure that the pump is getting
electrical power. NOTE-Always disconnect the pump from electrical outlet before checking.
• Check the pump discharge and tubing for kinks and obstructions.
• Algae buildup can be flushed out with a garden hose.
• Remove the pump filtering cover & pump chamber to access the impeller area. Turn the
rotor to ensure it is not broken or jammed.
With little flow rate, the pump will spew or "burp":
• Check the water level to make sure the pump is completely submerged.
If abnormal noise is heard during operation (with water):
• First disconnect the power supply and then remove pump filtering cover & pump chamber.
• Use hand to grip the impeller, gently pull the impeller/rotor assembly out of the pump
housing.
• Rinse the impeller/rotor assembly and the cavity with clean water. If breakage or surface
damage is found on the assembly, contact your distributor for part replacement.
Warning Ill
The water pump must be fully soaked or it will be damaged!
Minimum Water Leverl (Niveaude I'eau minimum)
Warning!!!
The water pump must be fully soaked or it
will be damaged!
Flow control valve
(+)Maximum (Debit maximum)
(-)Minimum (Debit minimum)