Ethicon Echelon Flex Mode D'emploi page 14

Recommended separation distances between portable and mobile RF communications equipment and
The ECHELON FLEX Powered Vascular Stapler is intended for use in an electromagnetic environment in which radiated RF disturbances
are controlled. The customer or the user of the ECHELON FLEX Powered Vascular Stapler can help prevent electromagnetic interference
by maintaining a minimum distance between portable and mobile RF communications equipment (transmitters) and the ECHELON FLEX
Powered Vascular Stapler as recommended below, according to the maximum output power of the communications equipment.
Rated maximum output power
of transmitter
W
0.01
0.1
1
10
100
For transmitters rated at a maximum output power not listed above, the recommended separation distance d in meters (m) can be estimated
using the equation applicable to the frequency of the transmitter, where P is the maximum output power rating of the transmitter in watts (W)
according to the transmitter manufacturer.
NOTE 1 At 80 MHz and 800 MHz, the separation distance for the higher frequency range applies.
NOTE 2 These guidelines may not apply in all situations. Electromagnetic propagation is affected by absorption and reflection from
structures, objects and people.
Storage Conditions
Temperature: -20 ºC — 30 ºC
Relative Humidity: 10% — 65%
Pressure: 500 — 1060 hPa
Storage and Transportation Conditions
Keep Dry
Keep Away from Heat
Operating Environment Conditions
Temperature: 10 ºC — 40 ºC
Relative Humidity: 30% — 75%
Pressure: 800 — 1060 hPa
How Supplied
The ECHELON FLEX Powered Vascular Stapler with Advanced Placement Tip endoscopic linear cutter is supplied sterile for single patient use.
Discard after use.
the ECHELON FLEX Powered Vascular Stapler
Separation distance according to frequency of transmitter
150 kHz to 80 MHz
Not applicable
9
m
80 MHz to 800 MHz
0.12
0.38
1.2
3.8
12
800 MHz to 2.5 GHz
0.23
0.73
2.3
7.3
23