Wilo Stratos GIGA2.0-I Notice De Montage Et De Mise En Service page 252

en
252
Faults, causes and remedies
Code Warning
Additional information
about causes and rem-
edy:
Analogue input func-
tions impaired.
563 Sensor value missing
2)
from BMS (building
management system).
Additional information
about causes and rem-
edy:
Control functions im-
paired. A replacement
function is active.
564 Setpoint missing from
2)
BMS .
Additional information
about causes and rem-
edy:
Control functions im-
paired. A replacement
function is active.
565 Signal too strong at
analogue input AI1.
Additional information
about causes and rem-
edy:
The signal is processed
with the maximum
value.
566 Signal too strong at
analogue input AI2.
Additional information
about causes and rem-
edy:
The signal is processed
with the maximum
value.
567 Calibration of Wilo
sensor missing.
Additional information
about causes and rem-
edy:
The pump function is
slightly impaired. The
pump can no longer ac-
curately
determine the volume
flow.
569 Configuration missing.
Cause Remedy
Sensor source or Check configuration and
2)
BMS is configured function of BMS
incorrectly.
Communication has
failed.
Sensor source or Check configuration and
2)
BMS is configured function of BMS
incorrectly.
Communication has
failed.
The available signal is Check input signal.
significantly over the
expected maximum.
The available signal is Check input signal.
significantly over the
expected maximum.
Concurrent replace- Replacement of a compo-
ment of electronic nent, short commissioning
module and sensor and fresh replacement
with spare parts. with the spare part.
Pump configuration is Configure pump. Software
missing. update is recommended.
2)
.
2)
.
WILO SE 2021-12