Wilo Stratos GIGA2.0-I Notice De Montage Et De Mise En Service page 224

en
224
Communication interfaces: Setting and function
...►
Set control mode
Setting assistant
Current: radiator – differential pressure Δp-
v
setpoint delivery head (Δp-v)
Current: 6.0 m
External setpoint source
Analogue input 2
Q-Limit Max
Status: switched off
Fig. 71: External setpoint source
Possible selection:
Set input for external setpoint
Select setpoint source
Set setpoint source
Substitute setpoint in the event of a cable break
Table 48: Set input for external setpoint
The setpoint source can be changed in select "Setpoint source".
Setpoint source
Analogue input 1
Analogue input 2
Analogue input 3
Analogue input 4
CIF module
Fig. 72: Setpoint source
The setpoint source should be configured when an analogue input is used as source. To
do this, select "Set setpoint source".
Set input for external setpoint
Select setpoint source
Set setpoint source
Substitute setpoint in the event of a cable break
Table 49: Set input for external setpoint
Possible selection of type of use to be adjusted:
Linking the setpoint to
an external
setpoint source and
setting the
setpoint source
.
Setpoint comes from
analogue input (AI2)
WILO SE 2021-12