en
194
Setting the control functions
System types for heating application
‣ Underfloor heating
‣ Ceiling heating
‣ Fan heater
‣ Concrete core heating
‣ Hydraulic shunt
‣ Differential pressure-less distributor
‣ Buffer heating
‣ Heat exchanger
‣ Heat source circuit
(heat pump)
‣ District heating circuit
‣ Basic control modes
Table 22: Selection system type and control mode for "Heating" application
After having selected the desired system type and control mode for the "Heating" ap-
plication, select the control mode for the "Cooling" application.
System types for cooling application
‣ Ceiling cooling
‣ Underfloor cooling
‣ Air-conditioning device
‣ Concrete core cooling
Control mode
Differential pressure Δp-c
Dynamic Adapt plus
Hall temperature T-const
Differential pressure Δp-v
Dynamic Adapt plus
Hall temperature T-const.
Differential pressure Δp-c
Dynamic Adapt plus
Feed/return ΔT
Volume flow cQ
Sec. feed temperature T-const.
Return ΔT
Multi-Flow Adaptation
Volume flow cQ
Multi-Flow Adaptation
Volume flow cQ
Sec. feed temperature T-const.
Feed ΔT
Multi-Flow Adaptation
Volume flow cQ
Feed/return ΔT
Volume flow cQ
Differential pressure Δp-c
Differential pressure Δp-v
Index circuit Δp-c
Differential pressure Δp-c
Differential pressure Δp-v
Index circuit Δp-c
Dynamic Adapt plus
Volume flow cQ
Temperature T-const
Temperature ΔT-const.
Speed n-const.
Control mode
Differential pressure Δp-c
Dynamic Adapt plus
Hall temperature T-const
Differential pressure Δp-v
Dynamic Adapt plus
Hall temperature T-const.
Differential pressure Δp-c
Dynamic Adapt plus
Feed/return ΔT
Volume flow cQ
WILO SE 2021-12