Wilo Stratos GIGA2.0-I Notice De Montage Et De Mise En Service page 147

Fig. 1: Pump overview
2
1
Fig. 2: Rating plates
Fig. 3: Functional assemblies
Installation and operating instructions Wilo-Stratos GIGA2.0-I, Wilo-Stratos GIGA2.0-D
Description of the pump
Item Name
1 Transport lugs
2 Pump housing
3 Motor
4 Graphic display
5 Electronic module
6 Electrical fan
7 Protective plate in
front of lantern
window
8 Slot for Wilo-Smart
Connect Module
BT
9 Differential pres-
sure sensor
Table 2: Description of the pump
ƒ
Item 3: the motor with mounted electronic module can be rotated relative to the
lantern. Observe the instructions in the "Permitted installation positions and
change of the arrangement of components before installation" [} 154] section.
ƒ
Item 4: the display can be rotated in 90° steps as required (see section "Electrical
connection" [} 165]).
ƒ
Item 6: an unobstructed and free air flow must be ensured around the electric fan
(see "Installation" [} 152] section).
ƒ
Item 7: the protective plate must be dismantled for the leakage check. Observe the
safety instructions in "Commissioning" [} 176] section!
ƒ
Item 8: for installing the Wilo-Smart Connect Module BT, see "Installation Wilo-
Smart Connect module BT" [} 175] section.
Rating plates (Fig. 2)
1 Pump type rating plate
ƒ
There is a serial number on the pump type rating plate. It must be specified e.g. for
ordering spare parts.
ƒ
The drive type plate is located on the side of the electronic module. The electrical
connection must be designed according to the specifications on the drive type rat-
ing plate.
Functional modules (Fig. 3)
Item Name
1 Hydraulic unit
2 Differential pres-
sure sensor (op-
tional)
3 Drive
4 Motor
5 Electronic module
6 Impeller
Explanation
Used for transporting and lifting the components. See
"Installation" [} 152] section.
Installation according to "Installation" section
Drive unit Forms the drive together with the electronic
module.
Provides information about settings and pump status.
Self-explanatory user interface for setting the pump.
Electronic unit with graphic display.
Cools down the electronic module.
Protects against rotating motor shaft.
Wilo Connectivity Interface as slot for the Bluetooth
module
2 ... 10 V with capillary tube connections on flanges of
suction and discharge side
2 Drive type rating plate
Description
The hydraulic unit consists of pump housing, impeller
and lantern.
Differential pressure sensor with connection and fixation
elements
The drive consists of a motor and an electronic module.
Electronic unit
en
147