Wilo Stratos GIGA2.0-I Notice De Montage Et De Mise En Service page 226

en
226
Communication interfaces: Setting and function
Use standard values
Analogue input (AI2)
Specifications
User-defined settings
Fig. 75: Use standard values
Defined standards for the transfer of the signal are used with "Use specifications". Fi-
nally the setting of the analogue input is ended as setpoint sensor.
OFF:
ON:
Min:
Max:
Table 50: Standard signal assignment
With the selection of "User-defined settings", additional settings must be made:
For the signal types "0 ... 10 V" and "0 ... 20 mA", a cable break detection with a para-
meterisable threshold can be optionally activated.
Optional cable break detection
Analogue input (AI2)
Switched off
Switched on
Fig. 76: Optional cable break detection
Select "Switched off" to switch off cable break detection.
Select "Switched on" to activate cable break detection only within an adjustable limit
value.
Set the signal/values
assignment.
1.0 V
2.0
3.0 V
10.0 V
Signal strength below
the set limit value
is interpreted as
a cable break.
WILO SE 2021-12