Siemens SINAMICS S Manuel page 1055

Bit 9 = 1 --> Ready to exchange process data
From the basic brake control (p0108.14 = 0) [2701.8]
From the basic brake control (p0108.14 = 0) [2701.8]
From the expanded brake control/standstill detection (p0108.14 = 1) [2711.8]
From the expanded brake control/standstill detection (p0108.14 = 1) [2711.8]
From the expanded brake control/standstill detection (p0108.14 = 1) [2711.5]
<1> The master system requests process data.
<2> When the "safe brake control" (SBC) is activated and selected, the brake is no longer controlled using this signal.
<3> These signals are only of significance when the "extended brake control" function module is activated (r0108.14 = 1).
1 2
DO: SERVO, VECTOR
Internal control/status words - status word sequence control
PROFIdrive bit
Bit No.
From the control unit [2610] 0
From the control unit [2610] 1
From the control unit [2610] 2
From the control unit [2610] 3
From the control unit [2610] 4
From the control unit [2610] 5
From the control unit [2610] 6
From the control unit [2610] 7
From the control unit [2610] 8
9
10
From the control unit [2610.4] 11
12
13
14
15
3 4
Status word sequence control
1 = Ready to power-up
1 = Ready to operate (DC link loaded, pulses blocked)
1 = Operation enabled (drive follows n_set)
1 = Jog active
1 = No coast down active (OFF2 inactive)
1 = No fast stop active (OFF3 inactive)
1 = Power-on inhibit active
1 = Drive ready
1 = Controller enable
1 = Control requested <1>
Reserved
1 = Pulses enabled
1 = Open holding brake (only for booksize units when the brake is
connected to the power unit)
1 = Command, close holding brake
<2>
1 = Pulse enable from the brake control
<3>
1 = Enable setpoint from the brake control
<3>
5 6
fp_2503_01_eng.vsd
01.02.06 V02.04.00
2000.00 µs
ZSW sequence ctrl
r0899
r0899.0
r0899.1
r0899.2
r0899.3
r0899.4
r0899.5
r0899.6
r0899.7
r0899.8
r0899.9
r0899.11
r0899.12
r0899.13
r0899.14
r0899.15
7 8
Function diagram
- 2503 -
SINAMICS S