Publicité
Les langues disponibles
Les langues disponibles
①Remove the threaded area and the connecting pivot of the remote control cable from the
governor lever. Adjust the cable stroke by adjusting the fastening distance of the threaded
area.
②Loosen the setting bolt of the remote control cable clamp bracket and adjust the fixing position
of the remote control cable.
(However, the adjustment of the remote control cable stroke must be made as in ① above.)
(4) Adjusting the Marine Gear Remote Control Cable
①Check to see that the clutch lever on the
marine gear side is in the neutral position
when the remote control handle is in
NEUTRAL.
②If the position of the clutch lever is incorrect,
Ioosen the setting screw of the cable bracket
and adjust the position of the cable.
③Check the clutch lever in
▲FWD (Forward) (Ahead )
▼REV (Reverse) (Astern)
making sure it is correctly aligned.
④Make any necessary adjustments using
NEUTRAL as the central point.
⑤Make sure the control cable is securely fas-
tened to the clutch lever.
For other models, refer to the marine gear
operation manual.
(5) Cleaning the Turbocharger Blower
Contamination of the turbocharger blower caus-
es blower speed to drop and engine output to
down.
①Prepare blower cleaning agent, fresh water
and a small pitcher.
②Remove the pre-cleaner (filter) of the tur-
bocharger air inlet.
③Pour about 50cc of blower cleaning agent little
by little at about 10 second intervals through
the air inlet under no load operation (2500-
~3000 rpm)
④Wait about 3 minutes, and pour 50cc fresh
water into the air inlet in the same manner at
about 10 second intervals.
[Fig.23]
Cable bracket
Clutch lever
Adjusting the marine gear remote
control cable (KMH6A, KMH6A1)
Fresh water tank
Turbo charger
[Fig.24]
_
_
40
Setting screw
Ahead
NEutral
Astern
Lube oil
filter
Publicité
