Yanmar 6LYA-STP Mode D'emploi page 25

3.2.3 Supplying lube oil to marine gear
(for Yanmar model KMH6A, KMH6A1)
1) Remove the filler cap and supply the lube oil
to the marine gear.
2) Supply lube oil up to the upper limit on the oil
dipstick. To check the oil level, insert the
dipstick in fully.
Lube Oil Capacity : Full 4.0
3) Fasten the filter cap fully.
3.2.4 Supplying Cooling Water
Supply cooling water according to the following
procedures. Be sure to add LLC to the fresh water.
1) Close the water drain cocks (Close both the
fresh water line drain cocks and the sea
water line drain cocks.)
Number of drain Cock
Fresh water line
2
(Note) The water drain cocks are opened
before shipping from the plant.
2) Remove the filler cap of the fresh water tank.
(Turn the filler cap by 1/3 turn
counterclockwise to remove.)
3) Supply cooling water slowly to the fresh
water tank so that no air bubbles will develop.
Supply until the water overflows from the filler
port.
4) After supplying cooling water, fasten the
filler cap firmly. If loose, trouble will occur due
to water leakage.
To fasten, align the notch at the rear of the
cap with the slot of the filler port and turn the
cap by 1/3 turn.
5) Remove the cap of the sub-tank, supply water
to the full limit and fasten the cap.
Sea water line
4
_
22
[Fig. 4]
[Fig. 5]
[Fig. 6]
[Fig. 8]
_
[Fig. 7]
( )
KMH6A
KMH6A1
[Fig. 9]