Arthrex Synergy Insufflation FM134 Instructions D'utilisation page 64

Error and Warning Messages
Error and warning messages
EN
Gas temperature >42°C/ Disconnect
Luer lock/Cool down tube
The device terminates gas heating
and insufflation.
Error message/Call service
Device temperature error/Turn
device off
Insufflation is stopped or cannot be
started.
Venting valve defective
60
Cause
The temperature of the gas
exceeds 42° C.
The device does not work prop-
erly The internal safety system
has been triggered.
The device temperature is
above 70 °C.
The device temperature is
below 10 °C.
Venting system malfunctioning. • Use the ON/OFF key to turn the device off and turn
Troubleshooting
• Unplug the insufflation tube at the trocar.
• Press the START/STOP function field. The device
insufflates without heating the gas.
• Let hot gas escape until the tube is only warm to
the touch.
• Continue the operation without gas heating or use
a different gas heating tube.
Turn device off and on again. This reactivates the
gas heating.
• Check gas heater after surgery using a different
tube.
If this error message is displayed again, have the gas
heater checked by a qualified service technician.
It is possible to continue using the device without gas
heater.
• Switch the device off and back on after approx.
3 seconds have expired using the ON/OFF key.
• The device is defective if the error message is dis-
played again. Make sure the device can no longer
be operated until a qualified service technician con-
ducts the appropriate tests and repairs.
• Prepare for changing the gas bottle.
• Turn the device off for about 10 minutes using the
ON/OFF key. The surrounding room temperature
must be above 10° C.
device back on after approx. 3 seconds. If this error
message is displayed again after the device check
has concluded, have the device checked by an
authorized service technician. The device can be
still operated but without venting system. The error
message is repeated with each Start/Stop.