Gas Connection; Connecting A Gas Bottle; Connecting To Central Gas Supply - Arthrex Synergy Insufflation FM134 Instructions D'utilisation

60320. Grounding will only be reliable if the equipment is connected to a corre-
sponding hospital grade socket.
Integrate the device into the potential equalization system as specified by local
safety rules and regulations.
4.3

Gas Connection

WARNING!
Medically pure CO
2
Make sure to use only medically pure CO
mixtures of gases, high pressure compressed gases, gases with entrapped liq-
uids, or polluted gases must not be used with this device.
Use a high-pressure tube to connect a CO
or connect to a centralized CO
4.3.1

Connecting a Gas Bottle

CAUTION!
Always use a high-pressure tube to connect gas bottle and device.
The gas bottle must be in a vertical position. The gas bottle pressure may not ex-
ceed 80 bar or be less than 15 bar.
CAUTION!
Gas bottles with riser pipe can release dirt and oily fluids into the device. Do not
use a gas bottle with riser pipe.
4.3.2

Connecting to Central Gas Supply

Use the following device connectors available as additional equipment to con-
nect to a central gas supply (house supply):
• 2200703 for house gas supply NIST or
• 2200702 for house gas supply DISS
1. Attach the high-pressure tube to the gas connection.
2. Fasten the high-pressure tube with the nut.
3. Tighten the nut.
The type of corresponding gas supply must be set in the configuration menu (see
chapter 8.1.3 Setting the Gas Supply Type, page 38).
. Other gases (i.e., helium, N
2
gas cylinder to the rear gas supply port
2
gas supply.
2
Potential equalization
O, argon),
2
Initial Device Startup
EN
13