Arthrex Synergy Insufflation FM134 Instructions D'utilisation page 12

Insufflateur pour la laparoscopie
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 141
General Information
EN
8
necting a Gas Bottle).
WARNING!
Contamination
Do not use device and/or accessories if signs of contamination are detected.
Make sure the device or/and accessories can no longer be operated until a qual-
ified service technician conducts the appropriate tests and repairs.
WARNING!
Fatigue symptoms
When there is a high level of CO
the operating area with enough fresh air, since an increasing CO
can cause the medical personnel to suffer fatigue symptoms, an inability to con-
centrate, unconsciousness, or even death.
WARNING!
The venting rate of the automatic venting system is limited. Always monitor the
actual pressure when using additional insufflation sources.
WARNING!
Contaminated filter
Replace a contaminated filter immediately during surgery to ensure unhindered
gas flow.
WARNING!
Connecting the tube
Always use the proper tube set for the device. The tube outlet may only be con-
nected to instruments which are intended for intra-abdominal CO
WARNING!
Electronic device control
Do not close the valve at the trocar sleeve during surgery. The electronic control
unit of the device adjusts the actual pressure as desired.
WARNING!
Medically pure CO
2
Make sure to use only medically pure CO
mixtures of gases, high pressure compressed gases, gases with entrapped liq-
uids, or polluted gases must not be used with this device.
WARNING!
Service connection
The connected equipment must comply with the standard EN 60950 in the cur-
rently valid version. Do not connect a device to the service connection during sur-
gery.
consumption, you should make sure to supply
2
. Other gases (i.e., helium, N
2
level in the air
2
insufflation.
2
O, argon),
2

Publicité

Table des Matières
loading

Table des Matières