Start, Operation, Stop; Start; Operation - battioni Pagani WPT Série Notice D'emploi Et D'entretien

Instruction Manual
for WPT, KTS, KPS, KTM, WSM series use and maintenance

8.1 - START

The Rotary blades vacuum pump does not have a start button. Therefore to start it up just transmit motion to the power take-off in a
different way according to the Rotary blades vacuum pump version. Make sure, before the start up, that the Rotary blades vacuum
pump is supplied with lubricating oil in the internal part (and in the gearbox for M and MA, K and KA versions).
Before starting the Rotary blades vacuum pump make sure that the guards on all the moving parts are in place
and efficient. Any damaged or missing components must be replaced or installed correctly before using the
transmission.
In M, MA, D clean and grease the power take-off before installing the cardanic transmission.

8.2 - OPERATION

Do not use the Rotary blades vacuum pump at pressure higher than those indicated in the table 5. During use
do not exceed the speed and power limits set in this manual. Avoid overloads and under-load functioning of the
power take-off.
Check the following operating parameters.
PARAMETER
Speed
M, G, K
Speed
P, D, H
Speed
WSM 2700 - 3300 P
Speed
MA, GA, KA
Pressure
Vacuum
Cylinder external temperature compression side
Table 5
WPT480 WPT600 WPT720 KTS840
70 72 74
Rotary blades vacuum pump noise level at 60% vacuum with silencer at a distance of 7 m in open field conditions.
Failure to comply with the instructions given in this manual may be dangerous for the user health or may damage
the Rotary blades vacuum pump . If the material to be sucked density is high, dilute or mix the material. The
working time should be such that the maximum temperature is never reached. Prolonged operation without
interruption may cause damage to the blades as well as overheating.
pag. 58

8.0 - START, OPERATION, STOP

[rpm]
[rpm]
[rpm]
[rpm]
[bar]
[%]
[°C]
SOUND PRESSURE LEVEL LpA (dB)
KTS960 KTS1080 KPS 490
74 75 75 75
WORKING RATE
450-500
1000 (1200 for KPS)
800
800
0,5 – 1
80 %
60 – 70
KPS 550 KPS 670 KTM1200 KTM1500 KTM1800 KTM2300 WSM2700 WSM3300
78 79 76
WORKING RATE
600
1200 (1400 for KPS)
1000
1000
1,5
95 %
100
76 77 77 78 79