Hydraulic Diagram (H Version); Hydraulic Motor Use And Maintenance Instructions - battioni Pagani WPT Série Notice D'emploi Et D'entretien

Aspirator Water pump flow
Compressor rate[ l/min ]
WPT
KTS
KPS
KTM 1200
KTM 1500
KTM 1800
KTM 2300
WSM 2700 - 3300
Table 2

3.5 - HYDRAULIC DIAGRAM (H VERSION)

The hydraulic system required for the operation of the Rotary blades vacuum pump .../H is schematized in the version with
unidirectional and bi-directional motor shown below and the technical characteristics of the hydraulic motor in table 1.
The splining of the hydraulic motor is of type SAE 16/32" D.P. for KTS and KTM series, Z=23 DIN 5482-Z23 for WPT series. The
direction of rotation of single-acting motors must match circuit connections. Check that the coupling flange correctly aligns the user
shaft and the motor shaft.

3.6 - HYDRAULIC MOTOR USE AND MAINTENANCE INSTRUCTIONS

Make sure, with unidirectional motors, that the rotation direction is consistent with the circuit connections. Check that the coupling
flange correctly aligns the user shaft and the motor shaft.
1
2
for WPT, KTS, KPS, KTM, WSM series use and maintenance
Pump speed
Water [ rpm ]
12 1000
30 1000
30 1000
60 2000
60 2000
60 2000
60 2000
60 2000
HYDRAULIC SYSTEM
UNIDIRECTIONAL MOTOR
2
4
5
3
4
Water tank
content
20
40
20
25
27
62
75
60
M
1
WPT - KTS - KPS - KTM - WSM
6
3
M
7
5
6
Instruction Manual
Pipes Diameter Heat to be
[ " ] dissipated [ kJ/h ]
½" 63.000
63.000
63.000
63.000
63.000
63.000
63.000
1" 120.000
7
pag. 45