Gears Replacement (M-Ma, K-Ka Versions); Technical Support; Regular Servicing - battioni Pagani WPT Série Notice D'emploi Et D'entretien

Instruction Manual
for WPT, KTS, KPS, KTM, WSM series use and maintenance

10.5 - GEARS REPLACEMENT (M-MA, K-KA VERSIONS)

1. Unscrew the screws of the gearbox cover;
2. Use two screws to screw into the threaded extraction holes until the cover is removed;
3. Take out the gear with splined shaft using an extractor if necessary;
4. For the pinion: unscrew the self-locking nut, use an extractor or a press.

10.6 - TECHNICAL SUPPORT

Contact Battioni Pagani authorized distributors for technical assistance or accessories and spare parts supply.
®

10.7 - REGULAR SERVICING

SERVICING TO BE CARRIED OUT
Check oil circulation
Check / clean the filter cartridge
Check oil level in tank
Check that the over-pressure and vacuum
regulator valves are working correctly
Check that the overflow valves are working
correctly
Lubricate power take-off
(M - MA - K - KA - D)
Wash and clean the valves
Check wear of blades
Wash oil tank
Wash body internally
Wash lubrication pump
pag. 64
HOW TO PROCEED
View the control lights
• Open the filter cover on the collector through the 4
eyebolts;
• remove the cartridge;
• clean with water and / or compressed air preventing the
dirt from falling inside the collector
• move the plate to verify proper operation
• reassemble all parts
Use the oil level outside the tank
Remove valves
Remove valves
Oil Power take-off with brush and lubricating oil
Remove valves
Remove threaded plug
Remove tank
Cleaning with "Flushing Kit", enter "Flushing Fluid" (after
washing only lubricate) and dispose of the products and
the cleaning residues adhered to the rules laid down for oil
chemicals
Use a brush and compressed air
FREQUENCY
Once a day
Once a week
Once a week
Once a month
Once a month
Once a month
Once a month
Every 300 working hours
Once a year
Whenever sewage enters or
when inactive for a long time
Once a year or for prolonged
inactivity