Overpressure Valves And Vacuum Adjustment Valves - battioni Pagani WPT Série Notice D'emploi Et D'entretien

Instruction Manual
for WPT, KTS, KPS, KTM, WSM series use and maintenance
KTM 1800 - 2300, WSM 2700 - 3300.
If a different setting is required proceed as follows:
• Unscrew oil filling plug located on oil tank;
• If oil inside oil tank covers the lubrication pump, reduce oil level to half tank by unscrewing oil discharge plug;
• Push a screwdriver into the filling oil plug hole and adjust the oil flow;
• Turn the screw clockwise to increase the oil flow;
• Turn the screw anticlockwise to decrease the oil flow (see Figure 10) (this operation must be done for all the lubrication
pump pistons);
• Remove the screwdriver and close the plug.
Figure 10
Automatic lubrication pump
KTM 1800 - 2300, WSM 2700 - 3300.

6.0 - OVERPRESSURE VALVES AND VACUUM ADJUSTMENT VALVES

The following diagram describes the valves as series (O), on demand (X) and not available (-) for each model of Rotary blades vacuum
pump.
WPT
KTS
KPS
KTM
WSM
O = As standard
Table 4
pag. 56
VALVOLA REGOLAZIONE
VUOTO 1" 1/2
O
O
X
-
-
X = On request
VALVOLA SOVRAPRESSIONE
2"
O
-
-
-
-
- = Not available
VALVOLA SOVRAPRESSIONE
2" 1/2
-
O
-
-
-