Lubricating Oil Quantity; Lubricating Oil Adjustment - battioni Pagani WPT Série Notice D'emploi Et D'entretien

MODELS
WPT 480
WPT 600
WPT 720
KTS 840
KTS 960
KTS 1080
KPS 490
KPS 550
KPS 670
KTM 1200
KTM 1500
KTM 1800
KTM 2300
WSM 2700
WSM 3300

5.5 - LUBRICATING OIL ADJUSTMENT

The adjustment of oil delivery, in automatic lubrication, is carried out at our factory during the final testing of the Rotary blades
vacuum pump. If for any reason a different setting is required proceed as follows: remove pin cover (see Figure 9), loosen lock
nut "C" and then turn regulator pin "A". By rotating clockwise the oil delivery will be lower (-), by rotating anticlockwise the oil
delivery will be higher (+). When adjustment has been completed tighten lock nut "C" and screw back the cover.
Figure 9
for WPT, KTS, KPS, KTM, WSM series use and maintenance

5.4 - LUBRICATING OIL QUANTITY

OIL
QUANTITY
During the Rotary blades vacuum pump operations check that amount of oil
[g/h]
indicated in table 3 drops from the regulating cock. These amounts are valid
120
for the Automatic Lubrication. When necessary to add in the tank, put only new
140 and clean oil.
VERSIONE .../M-MA .../K-KA: the first gearbox oil change is to be done
140
after about 100 hours of actual work; the following changes can be done every
140
300 hours of actual work.
180
Where provision is a particularly intense operation is recommended to increase
240
the oil consumption of 8-10%.
140
The Table 3 summarizes the oil consumption for each model.
180
240
240
240
320
320
320
320
Table 3
Instruction Manual
pag. 55