Recommended Spare Parts; Lubricants Suggested For Lubrication; Oil Level Inspection; Oil Top Up - battioni Pagani BLW Serie Notice D'emploi Et D'entretien

6.3 - RECOMMENDED SPARE PARTS

The table shows the recommended spare parts for normal use of the vacuum/pressure blowers pump according to their envisaged
service life.
DESCRIPTION
Bearings and ring nuts (KIT)
Cogged wheels (KIT)
Segment seals (KIT)
Lip seal-type seals (KIT)
OIL CAPS (KIT)
Seals (KIT)
Check valve

6.4 - LUBRICANTS SUGGESTED FOR LUBRICATION

For lubrication of the vacuum/pressure blowers pump, the use of an ISO VG 220 synthetic oil based on polyalphaolefins for high
temperatures is recommended. In the internal tests carried out at our factory, the Mobil SHC 630 oil based on PAO was tested.
Do not use mineral oil with EP additives or synthetic oil based on silicones or diesters.

6.5 - OIL LEVEL INSPECTION

• Upon each use check of the pump check the oil level by means of the oil level inspection points.
• Repeat the operation both in the front casing and in the rear casing.
• The oil level must be checked with the pump stopped and cold

6.6 - OIL TOP UP

If, at the end of a periodic inspection, the oil level proves to be low, top up.
• Unscrew and remove the oil filler cap.
• Add the correct quantity of oil, checking the level from the oil level inspection point.
• Tighten the filler cap.
• Repeat the operation both in the front casing and in the rear casing.

6.7 - OIL CHANGE

Every 1000 hours of work or 12 months, replace the oil in both the front casing and in the rear casing.
• Place a container suitable to recover the used oil beneath the oil drain plug.
• Unscrew and remove the oil drain cap.
• To facilitate the emptying process, unscrew and remove the oil filler cap.
• Before proceeding to insert the oil in the casings, check that the oil drain plugs are tightly closed.
• Open the oil drain plugs and proceed with oil insertion to the pre-set level using a fully synthetic oil PAO ISO VG 220.
• Repeat the operation both in the front casing and in the rear casing.
• Tighten the oil filler caps.
MODEL
BLW 185 -210 - 255 - 270 PM
BLW 300 - 355 - 400 PM
BLW 140 P - H
BLW 210 - 270 P - H
BLW 300 - 400 P - H
OPERATION
1 year 3 years
- 1
- 1
- 1
1 2
1 2
1 2
- 1
rear casing oil level
FRONT CASING
0.80 litres
0.90 litres
0.25 litres
0.30 litres
0.35 litres
for use and maintenance of BLW series
5 years
2
Battioni Pagani
responsibility for breakages or
2
accidents due to the use of non-
2
original spare parts.
4
4
4
2
front casing oil level
OIL QUANTITY
REAR CASING
0.80 litres
0.90 litres
0.35 litres
0.80 litres
0.90 litres
instruction manual
disclaims any
®
TOTAL
1.6 litres
1.8 litres
0.6 litres
1.1 litres
1.25 litres
page 41