Packing, Storage, Handling And Transportation; General Instructions For The User And Operator; Packaging; Storage - battioni Pagani BLW Serie Notice D'emploi Et D'entretien

2.0 - PACKING, STORAGE, HANDLING AND TRANSPORTATION

2.1 - GENERAL INSTRUCTIONS FOR THE USER AND OPERATOR

Before starting the vacuum/pressure blowers pump, it is essential that the operator knows how to perform all the operations described
in this manual and how to apply them each time during use or maintenance of the vacuum/pressure blowers pump.
The operator should not perform under their own initiative operations or interventions that are not permitted in this manual.
Before maintenance or repair on the blowers pump it is necessary to make sure that it is impossible to start the vacuum/pressure blowers
pump. It is therefore mandatory to disconnect the pump from the belts if version P or PM, or from the hydraulic system if version H.
This is to prevent accidental start-up which could cause injury to persons and/or damage to the vacuum/pressure blowers pump.
Starting from 70°C the user must install and the operator must use adequate protection devices to prevent direct contact with hot parts
of the blowers pump. Before carrying out maintenance or repair operations on the vacuum/pressure blowers pump, wait for it to cool
down to at least a temperature of below 40°C.

2.2 - PACKAGING

The vacuum/pressure blowers pump is supplied unpacked. Upon request the following packaging types are available:
• Wooden base and shrink-wrap;
• Wooden cases and shrink-wrap for shipment by sea or air;

2.3 - STORAGE

In order to preserve the vacuum/pressure blowers pump correctly, it must be stored:
• Indoors, sheltered from adverse weather conditions;
• Resting horizontally on its four feet.
• Climatic storage conditions:
Temperature between -20°C and 40°C
Relative humidity from 15% to 80%
For different weather conditions, contact the Battioni Pagani
• The material stored in the warehouse must be protected periodically (every 6 months) with protective oil which must be sprayed
on the inside of the pump to protect the rotors and the pump body.

2.4 - HANDLING AND TRANSPORTATION

To view the data concerning the mass of the BLW vacuum/pressure blowers pump, consult the technical data annexed to paragraph
1.3 - TECHNICAL DATA.
The BLW vacuum/pressure blowers pump must be handled:
• Exclusively using equipment with adequate load and capacity strength.
• Harnessed with a strap;
• Lifted by forklift truck (if on pallet), bridge crane, crane or hoist.
Loosen the screws that secure the 4 feet of the vacuum/pressure blowers pump to the pallet.
For safety reasons, use a strap to lift the vacuum/pressure blowers pump.
Pass the strap beneath the vacuum/pressure blowers pump, between the fixing feet, as shown in the figure, or between the body and
the manifold where possible.
Attach the strap to the lifting equipment.
for use and maintenance of BLW series
technical office
®
instruction manual
page 33