Use And Maintenance Instructions; Packaging, Storage, Handling And Transport; Packaging; Storage - battioni Pagani WPT Série Notice D'emploi Et D'entretien

Instruction Manual
for WPT, KTS, KPS, KTM, WSM series use and maintenance

USE AND MAINTENANCE INSTRUCTIONS

2.0 - PACKAGING, STORAGE, HANDLING AND TRANSPORT

2.1 - PACKAGING

The Rotary blades vacuum pumps are supplied without packaging. On request the following packaging can be used:
• wooden base and shrink-wrap;
• wooden cases and shrink-wrap for shipment by sea or air;

2.2 - STORAGE

For a proper conservation of the Rotary blades vacuum pump, it must be stored:
• under cover, sheltered from adverse weather conditions;
• resting horizontally on its four feet.
The Rotary blades vacuum pumps are lubricated during testing at our factory with special oil that ensures lubrication of the various
internal components for approximately 6 month. In the event of extended periods storage it is advisable to wash the inside of the
pump body with oil and diesel oil (as reported in this manual).

2.3 - HANDLING AND TRANSPORT

Rotary blades vacuum pump mass: (see attached technical data).
Warning! Do not move the KPS using the 4 eyebolts filter cover but
only and exclusively for the eye bolts on the body.
The Rotary blades vacuum pump should be:
• Strapped with metal hooks to be inserted in the gripping hole, or with a band;
• Lifted with a hoisting truck (if on pallet), bridge crane, or crane.
Rotary blades vacuum pump is supplied with a guard that is in compliance with EC directives. This guard should be fitted on by the
fitter using the screws supplied.
3.0 - ASSEMBLY, FITTING, INSTALLATION,
The procedures concerning Rotary blades vacuum pump versions .../G .../GA ... are given in the GARDA/LEDRA group manual.
When carrying out maintenance operations, inspection and check, repairs, it is advisable to wear the
individual protection devices listed in this manual.
All maintenance operations, inspections and checks, repairs must be carried out with the greatest
attention and with the Rotary blades vacuum pump off and with the power take-off disconnected.
It is essential to prevent sewage from entering Rotary blades vacuum pump.
The entrance of sewage would cause the blades and consequently the rotor to break.
It is therefore necessary to equip the system with an overflow valve "12" and a safety overflow valve "11"
between the Rotary blades vacuum pump and the tank-cart (see Figure 1).

3.1 - INSTALLATION DRAFT

10
9
14
7
6
pag. 40
DISASSEMBLY, RE-FITTING
11
8
5
4
1
2 3 13
1 Rotary blades vacuum pump
2 Side manifold with check valve
3 Pulley
12
4 Cooling pump
5 Suction filter
6 Radiator
7 Feed Tank
8 Pneumatic rotating cylinder
9 4 way cock
10 Silencer
11 Secondary valve
12 Primary valve
13 Pneumatic clutch
14 Hand wheel cock
Figure 1