Instruction Manual; For Wpt, Kts, Kps, Ktm, Wsm Series Use And Maintenance; Introduction; Warranty - battioni Pagani WPT Série Notice D'emploi Et D'entretien

Instruction Manual

Instruction Manual

for WPT, KTS, KPS, KTM, WSM series use and maintenance

for WPT, KTS, KPS, KTM, WSM series use and maintenance
The Battioni Pagani Rotary blades vacuum pump series have been designed and constructed in compliance with EEC safety
®
regulations and have been assessed for risks according to standard UNI EN ISO 12100:2010; in particular they are in conformity
with directive 2006/42/EC and subsequent modifications and additions.
The pump in question is configured as defined in the Machinery Directive 2006/42/EC as machine and therefore has CE marking on
the identification label. It is however specified, in relation to its use and to the supply that takes into account the installation on the
buyer behalf (without motive force) that Battioni Pagani
in the use and maintenance manual.
This manual contains the EC Declaration of Conformity of the machinery with the above-mentioned directive and all the instructions
necessary for users and plant constructors to use our products in safety; therefore this manual must always be kept in the vicinity of
the Rotary blades vacuum pump. The instructions contained in this manual must be read carefully before carrying out any operation
with or on the pump.
This danger symbol in the manual means that important safety instructions are given. This information is
destined primarily for the operator whose responsibility it is not only to comply with them personally, but also to
ensure compliance by other persons exposed to the connected risks.
The descriptions and illustrations in this manual are purely indicative.
The manufacturer reserves the right to make any type of change to this manual at any time..
At the moment of receiving the Rotary blades vacuum pump check that it is complete with all its parts.
Any anomalies or missing parts must be notified within 8 days of receipt of the product.
The Supplier guarantees that goods sold are immune from imperfections and it is mandatory, where these imperfections are clearly
attributable to the manufacturing process and the materials use, to repair it or, based on their final decision, to replace defective
pieces. In any case the costs of labour, travel and transport, and any customs expenses shall be paid by the Purchaser. The seller is
not responsible for compensating any damages except in case of fraud or serious fault. Any parts that are subject to normal wear are
excluded from the warranty. Any warranty terminates if:
• any defects found are a result of accidents or obvious neglect or negligence on the part of the Purchaser,
• parts have been modified, repaired or installed by persons that were not authorised by the seller,
• malfunctions and breakdown were caused by non-suitable use or being subject to stress exceeding the limits set forth by the seller.
• when the Purchaser has not punctually complied with contractual payment obligations.
The Purchaser terminates any warranty rights if any imperfections are not communicated to the seller within 8 days from when they
are discovered, according to art. 1512 of C.C. The Seller reserves the right to change or improve their product without having an
obligation to carry out those changes or improvements on units that were previously produced and/or delivered. The Seller is not
liable for accidents or effects of accidents cause to persons or property as a result of material and/or manufacturing defects.
Thank you for choosing Battioni Pagani
pag. 34

INTRODUCTION

disclaims any liability due to noncompliance with the requirements listed
®

WARRANTY

.
®
Battioni Pagani
®