Disassembly Of The Back - battioni Pagani WPT Série Notice D'emploi Et D'entretien

2) remove the pins;
3) bring the front flange up to the pump body, positioning it in alignment
with the clamping holes;
4) tighten the clamping screws of the front flange to the body;
5) connect the lubrication tube by screwing it to the connecting piece
placed on the front cover;
6) fix the hydraulic motor transmission coupling to the anterior pin by the
screw located inside the pin;
7) fix the hydraulic motor support to the connecting flange;
8) fit the hydraulic motor to the hydraulic motor support by screws;

3.9.2 - DISASSEMBLY OF THE BACK

WPT SERIES
1) replace the back flange gasket;
2) bring the back flange up to the pump body, positioning it in alignment with the clamping holes;
3) tighten the clamping screws of the back flange to the body;
4) fit the bearing to the flange with an assembly pad;
5) position the connector joint in its seat in the rotor pin;
6) attach the lubrication pump to the back cover (or to the cooling pump in versions with water cooling system, preceded by the
spacer) and fasten with two screws;
7) insert the lubrication (or cooling) pump shaft in the connector joint;
8) tighten the four screws that fix the cover to the back flange;
9) connect the delivery tubes of the lubrication pump, inserting them in the connecting piece and pressing then until the quick
clamping hooks snaps;
10) fit the lateral tank support at the pump body;
11) attach the feeding tube from the later tank to the lubrication pump;
KPS SERIES
1) Remove the bearing from the rear flange;
2) Insert in the pump body the two centring pins
3) Replace the flange gasket;
4) Move the rear flange close to the pump body, aligning it with the holes of the two pins;
5) Insert the 6 new clamping screws in the slotted holes and tighten with 45 ÷ 55 Nm;
6) Assemble the bearing on the flange by using a hammer;
7) Insert the Seeger ring in the rear pin with the compensation ring;
8) Disassemble the back cover or the lubrication pump (together with the connection joint) on the flange;
9) Remove the centering pins.
KTS, KTM, WSM SERIES
1) Insert the front pin in its seat on the rotor, being careful to avoid putting the front pin in place of the back one and fasten it with
screws;
2) replace the back flange gasket;
3) bring the back flange up to the pump body, positioning it with dowel pins (supplied) in alignment with the clamping holes;
4) tighten the clamping screws on holes with a torque setting of 80 Nm;
5) remove the dowel pins;
6) position the connector joint in its seat in the rotor pin;
for WPT, KTS, KPS, KTM, WSM series use and maintenance
.../H .../G - GA
2) fix the coupling flange with screws;
3) assemble the pinion of the rotor pin;
4) assemble the locknut to fasten the pinion;
Instruction Manual
pag. 51