Stop; Controls Devices; Protective Devices; Personal Protective Equipment To Be Used - battioni Pagani WPT Série Notice D'emploi Et D'entretien

8.3 - STOP

To stop the Rotary blades vacuum pump, stop the engine and disconnect the power take-off in order to prevent its accidental
operation.

8.4 - CONTROLS DEVICES

To control the intake and compression phases there is a handle, placed on the upper side of the manifold and can be used manually.
To determine in which way turn the handle to select the intake or compression phases follow the instructions provided by the system
manufacturer. In case of gear blocking lift the handle with a lever.
The intake or compression selection made with the handle must be operated with the Rotary blades vacuum pump
not running.

8.5 - PROTECTIVE DEVICES

The Rotary blades vacuum pump, when being installed on a machine, must be equipped with a protective device to
isolate the moving parts of the transmission and prevent access to them by the operators.
M, MA, K, KA, D versions are equipped with a CE marked plastic protective device. It insulates and protect of power take-off
shaft when in motion.
It is necessary to protect the Rotary blades vacuum pump to avoid the remote danger of materials projection in
case of heavy breakage.

8.6 - PERSONAL PROTECTIVE EQUIPMENT TO BE USED

When operating the Rotary blades vacuum pump, the personal protection equipment prescribed by the machine
manufacturer on which the pump is installed is to be used.
for WPT, KTS, KPS, KTM, WSM series use and maintenance
Instruction Manual
pag. 59