Testing And Running In; Testing; Running In; Start-Up, Operation, Shutdown - battioni Pagani BLM Notice D'emploi Et D'entretien

During testing and break-in operations it
is advisable to use the personal protection
equipment listed to the side.

4.1 - TESTING

All Battioni Pagani vacuum/pressure blowers pumps are tested before delivery at our factory.
®

4.2 - RUNNING IN

The running in period foreseen for a vacuum/pressure blowers pump is 30 effective working hours. During that period the working
parameters must be reduced by 20%.
ATTENTION: do not operate the vacuum/pressure blowers pump in the opposite direction of rotation.

5.0 - START-UP, OPERATION, SHUTDOWN

5.1 - START-UP

During start-up, operation and shutdown
manoeuvres it is advisable to use the
personal protection equipment listed to the
side.
The vacuum/pressure blowers pump does not have a start command. To start it simply transmit motion to the PTO in the manner
appropriate to the version being used. Make sure, before starting the motor, that the vacuum/pressure blowers pump is supplied with
oil for lubrication of the bearings and gears in the front and rear casing.
Before starting the vacuum/pressure blowers pump, ensure that the guards on all the moving parts are in
place and efficient. Any damaged or missing components must be replaced and installed correctly.

5.2 - DAILY CHECKS TO BE PERFORMED

CHECKS TO BE PER-
FORMED
During the first few hours of operation, check that there are no abnormal vibrations
or noises. In the event of anomalies, stop the vacuum/pressure pump immediately and
contact the Battioni Pagani

4.0 - TESTING AND RUNNING IN

CHECK
Check Pressure
Check temperature
Check absorbed power
Check abnormal noises
Oil level (front and rear)
Service
®
for use and maintenance of BLM series
FREQUENCY
DAILY
instruction manual
page 29