battioni Pagani BLM Notice D'emploi Et D'entretien page 8

Instruction manual
for use and maintenance BLM series
MANDATORY SAFETY SIGNS THAT MUST BE AFFIXED BY THE
MANUFACTURER OF THE SYSTEM IN A VISIBLE POSITION NEAR THE
CAUTION
MOVING
PARTS
DO NOT ENTER THE
WORK AREA OF THE MOVING
CARDAN SHAFT, AVOID WORK
CLOTHING WITH LOOSE PARTS
OR FLAPS THAT MAY GET
CAUGHT IN MACHINERY
CONDITIONS AND LIMITS OF USE - LIST OF HAZARDS
The installation must be compliant, for member states of the EEC, with directive 2006/42/EC and subsequent amendments, while
for other states it must be compliant with local health and safety Legislation.
This rotary lobe vacuum/pressure pump has been designed to create a vacuum or pressure inside a tank to which it is connected.
No liquids, powders, or solids of any kind must enter the rotary lobe vacuum/pressure pump, as these may
cause it to break. It is therefore necessary to equip the system with overflow safety valves.
Any other use of the rotary lobe vacuum/pressure pump different to that specified is to be considered strictly
prohibited, not intended by the manufacturer and therefore highly dangerous.
Do not use the rotary lobe vacuum/pressure pump to transfer flammable and/or explosive liquids and
materials and materials that release flammable gases.
Do not use the rotary lobe vacuum/pressure pump in potentially explosive atmospheres.
Never remove the protections arranged on the pump and check their efficiency each time the machine is
used.
All operations must be carried out with the machine at a standstill and by qualified personnel.
Unqualified personnel is not authorised to work on or near the rotary lobe vacuum/pressure pump.
Battioni Pagani
application of the indications in the manual, non-compliance with current regulations and non-application
of due diligence during manoevring, maintenance or repair operations, even if not expressly stated in this
manual.
Failure to comply with the provisions contained in this manual shall give rise to the following dangers:
• Crushing hazard due to the weight of the rotary lobe vacuum/pressure pump during handling and transport;
• In-running nip point hazard in transmission components in the event the necessary protections are removed (avoid clothing with
wide sleeves, ties, bracelets, necklaces, etc.);
• Thermal type hazards due to the high temperatures reached by the rotary lobe vacuum/pressure pump;
• Noise hazard due to the noise produced and failure to wear personal protective equipment;
• Shearing hazard for the operator during testing, with the rotary lobe vacuum/pressure pump suction and delivery tubes disconnected
• Flying solid or liquid debris hazard following the serious breakage of the rotary lobe vacuum/pressure pump;
VIII
BLM ROTARY LOBE VACUUM/PRESSURE PUMP
CAUTION
HOT SURFACES
READ THIS MANUAL
BEFORE USING
THE PUMP
INDICATION OF DIRECTION OF HANDLE
ROTATION TO SELECT THE
SUCTION OR COMPRESSION PHASES.
shall not be liable for any inconveniences, breakages and accidents due to non-
®
HAZARD
HAND
CRUSHING
MAINTENANCE
TO BE PERFORMED
PLACE THE SAFETY
SIGNS IN A VISIBLE
POSITION NEAR
THE PUMP
MANDATORY
PERSONAL
PROTECTIVE
EQUIPMENT
pg. 5