Yamaha VX700F Manuel D'atelier page 98

A
B
SCH2725
C
STEERING SYSTEM/LUBRICATION
3. Adjust:
Adjustment steps:
•
•
•
SCH2720
CAUTION:
After tightening the inside and outside ball joint
locknuts 1, make sure the tie rod 2 can be
rotated freely through the ball joint travel. If not,
loosen the locknut 1 and re-position the ball joint
so that the tie rod 2 can be rotated freely. Tighten
the locknuts to specification.
Å
ı
Ç
SCH2730
LUBRICATION
Brake lever, throttle lever and throttle cable end
1. Lubricate the brake lever pivot, throttle lever and
SCH2735
Apply a dab of grease onto only the end of the
cables.
Do not grease the throttle cables.
They could freeze and cause a loss of control.
2-32
•
Ski toe-out
Loosen the locknuts (tie-rod) 1.
Turn the tie rods 2 in or out until the specified toe-
out is obtained.
Tighten the locknuts (tie-rod) 1.
Locknut (rod end) 1:
25 Nm (2.5 m · kg, 18 ft · lb)
®
LOCTITE
Left side
Right side
Inside
the ends of the throttle cables.
Recommended lubricant:
ESSO Beacon 325 Grease
WARNING
INSP
ADJ