Yamaha VX700F Manuel D'atelier page 178

8CH-10 8ED-10
6. Install:
•
Handlebar
CAUTION:
•
For SX700/MM700:
Be sure the projection on the handlebar is not
installed into the area a shown.
•
Be sure the side of the holder with the small
gap b faces forward.
SCH3150
•
Center the match mark c on the handlebar 1
between the lower handlebar holders 2.
Bolt (handlebar holder):
CAUTION:
•
First tighten the bolts on the front side of the
handlebar holder, and then tighten the bolts
on the rear side.
SCH3160
•
For SX700/MM700:
The handlebar for the SX700 (8CH5) has "8CH-
10" stamped on one end for identification. The
handlebar for the MM700 (8ED2) has "8ED-10"
stamped on one end. Since these handlebars
are specifically designed for the SX700 (8CH5)
and MM700 (8ED2), do not use them on any
future models.
SCH3170
SCH3180
3-7
CHAS
STEERING
23 Nm (2.3 m · kg, 17 ft · lb)