Yamaha VX700F Manuel D'atelier page 88

A
B
4
6
TRACK TENSION ADJUSTMENT
SCH2630
SCH2640
SCH2650
5
SCH2660
7
SCH2670
3. Adjust:
•
Track deflection
Adjustment steps:
•
Place the machine onto a suitable stand to raise
the track off of the ground.
•
Loosen the rear axle nut 1.
NOTE:
It is not necessary to remove the cotter pin 2.
a. Start the engine and rotate the track once or
twice. Stop the engine.
b. Check the track alignment with the slide runner 3.
If the alignment is incorrect, turn the left and right
adjusters to adjust.
Track alignment
4 Left adjuster
5 Right adjuster
8 Slide runner 9 Track
0 Track metal A Gap
Å VX700/VX700DX/SX700/VT700
ı MM700
c. Adjust the track deflection until the specified
amount is obtained.
Track deflection
4 Left adjuster
5 Right adjuster
CAUTION:
The adjusters should be turned an equal amount.
•
Recheck the alignment and deflection. If neces-
sary, repeat steps (a) to (c) until the specified
amount is obtained.
•
Tighten the rear axle nut.
Nut (rear axle):
75 Nm (7.5 m · kg, 54 ft · lb)
2-27
INSP
ADJ
6 Shifted 7 Shifted
to right to left
Turn out Turn in
Turn in Turn out
B Forward
More than Less than
specified specified
Turn in Turn out
Turn in Turn out