CARBURETORS
FUEL LEVEL ADJUSTMENT
1. Measure:
•
Fuel level a
Out of specification → Adjust.
Fuel level (from the bore center) a:
Measurement and adjustment steps:
•
Place the machine on a level surface.
•
Attach the fuel level gauge 1 to the float chamber
nozzle.
Fuel level gauge:
NOTE:
SCH7130
Use the adapter (outside diameter ø6 hose) 2 when
attaching the fuel level gauge.
•
Loosen the drain screw 3 and start the engine.
•
Place the tube along the seam line 4 of the
carburetor body.
•
Measure the fuel level a with the gauge.
•
If the fuel level is incorrect, adjust the fuel level.
•
Remove the carburetor.
•
Inspect the valve seat and needle valve.
SCH7140
•
If either is worn, replace them both.
•
If both are fine, adjust the float height by bending
the float tang 5 on the float.
•
Recheck the fuel level.
7-8
CARB
36 ~ 38 mm (1.42 ~ 1.50 in)
90890-01312, YM-01312-A