Yamaha VX700F Manuel D'atelier page 342

1 2
B/W B B/W B
B
O B Gy B
CYLINDER HEAD AND CYLINDER
SCH5360
3
B/W B
W B
Gy O
B W
SCH5370
SCH5380
5-16
9. Tighten:
•
Nuts (cylinder head)
Tightening steps:
•
Temporarily tighten the cylinder head nuts 1 ~ E
as follows.
1st step:
•
Tighten the nuts 1 ~ E.
Nut (cylinder head) 1 ~ E:
11 Nm (1.1 m · kg, 8.0 ft · lb)
2nd step:
•
Retighten the nuts 1 ~ E.
Nut (cylinder head) 1 ~ E:
23 Nm (2.3 m · kg, 17 ft · lb)
10. Connect:
•
Ignition coil leads
Ignition coil #1 Black/White lead →
Sub-wire harness Orange lead
Ignition coil #2 Black/White lead →
Sub-wire harness Gray lead
Ignition coil #3 Black/White lead →
Sub-wire harness White lead
Ignition coil #1, #2, #3 Black lead →
Sub-wire harness Black lead
NOTE:
Connect the black leads of the sub-wire harness to
the ignition coils as follows: the longest lead to
ignition coil #1, the medium-size lead to ignition coil
#2, and the shortest lead to ignition coil #3.
11. Install:
•
Plastic band
NOTE:
Pass the ignition coil leads as shown in the illustra-
tion.
ENG