Yamaha VX700F Manuel D'atelier page 198

4 Install the radius rod onto the trailing arm and tighten the bolt. Tighten the ball joint locknut and apply grease
to the ball joint. Repeat the procedure for the other side.
CAUTION:
When tightening the ball joint locknut, be sure to keep the ball joint outer housing centered with the ball
to prevent binding.
Ski alignment
NOTE:
Be sure to verify the spring preload setting and the ski spindle camber before adjusting the ski toe out since either
of those adjustments may affect the ski toe out setting.
Point the skis straight forward and measure the amount of ski toe out.
Å Ski toe out:
0 ~ 15 mm (0 ~ 0.59 in)
a – b = Toe out
Refer to "STEERING SYSTEM" in CHAPTER 2.
FRONT SUSPENSION
3-17
CHAS
SCH3370
SCH3380