Yamaha VX700F Manuel D'atelier page 218

PRIMARY SHEAVE AND DRIVE V-BELT
SCH4190
SCH4200
SCH4210
4-8
•
Tighten the spider to specification using the bar
wrench 3.
Spider:
200 Nm (20 m · kg, 145 ft · lb)
CAUTION:
The spider has a left-handed thread.
WARNING
•
Do not operate the primary sheave until the
LOCTITE ® has dried completely. Wait 24 hours
before operating the primary sheave.
•
Since a high torque is required to tighten the
spider, make sure the spider, fixed sheave, and
special tool are well secured. Tighten the spi-
der carefully to prevent cracks and damage to
the sheaves and spider.
5. Install:
•
Weight
Nut 1:
6 Nm (0.6 m · kg, 4.3 ft · lb)
NOTE:
To maintain the primary sheave balance, the bolts 2
must be installed with their threaded portions pointing
in a counterclockwise direction, as illustrated.
6. Install:
•
Primary sheave spring 1
•
Primary sheave cap 2
NOTE:
Be sure the sheave cap match mark (X) is aligned
with the spider match mark (X).
Primary sheave cap bolt:
14 Nm (1.4 m · kg, 10 ft · lb)
POWR
TR