Disassembly And Assembly - YAMAHA Marine 100A Manuel D'entretien

Table des Matières

Publicité

GEN
INFO
SAFETY WHILE WORKING
1080
1090
1100
3. Non-reusable items
Always use new gaskets, packings, O-
rings, split-pins, circlips, etc., on reas-
sembly.

DISASSEMBLY AND ASSEMBLY

1. Clean parts with compressed air when
disassembling.
2. Oil the contact surfaces of moving parts
before assembly.
3. After assembly, check that moving parts
operate normally.
4. Install bearings with the manufacturer's
markings on the side exposed to view,
and liberally oil the bearings.
5. When installing oil seals, apply a light
coating of water-resistant grease to the
outside diameter.
1-4
E

Publicité

Table des Matières
loading

Table des Matières