Table des Matières
Publicité
INSP
ADJ
3120
CONTROL SYSTEM
3110
3121
ADJUSTING THE REMOTE CONTROL
SHIFT CABLE
1. Inspect:
• Shift operation
Incorrect → Adjust.
2. Adjust:
• Remote control shift cable length
Adjustment steps
(1) Loosen the locknut 1.
(2) Remove the clip 2.
(3) Disconnect the shift cable joint 3.
(4) Set the remote control lever to the
neutral position.
(5) Align the center of the set pin a with
the mark b on the bottom cowling.
(6) Adjust the position of the shift cable
joint until its hole aligns with the set
pin c.
(7) Install the clip and tighten the locknut.
CAUTION:
The remote control cable joint must be
screwed in more than 8 mm (0.31 in).
ADJUSTING THE REMOTE CONTROL
THROTTLE CABLE
NOTE:
Before adjusting the remote control throttle
cable, be sure to adjust the ignition timing
and carburetor synchronization.
1. Inspect:
• Throttle operation
Incorrect → Adjust.
Inspecting steps
(1) Turn the throttle lever fully.
(2) Check the magneto control lever 1 so
that it contacts the full advance adjust-
ing screw 2.
3-12
E
3
3
Publicité
Table des Matières
