Publicité
Les langues disponibles
Les langues disponibles
11. LOADER CONTROL – TRAVEL
Danger
Risk of serious or fatal injuries when operating the loader!
Make sure there is no other person or living creature in the travel area.
Steer the vehicle with the left-hand control lever (1). The lever is located on the remote control (2). Move the control lever
smoothly. This will avoid sudden jolts and jerky movements while accelerating or braking.
Figure 23
Driving forward – push the control lever (1) forward.
Driving backwards – push the control lever (1) backwards.
Turn forward and left – push the control lever (1) forward and left.
Turn forward and right – push the control lever (1) forward and right.
Turn backwards and left – pull the control lever (1) backwards and right.
Turn backwards and right – pull the control lever (1) backwards and left.
Fast turn forward and left – push the control lever (1) left.
Fast turn forward and right – push the control lever (1) right.
34
12. CONTROLLING LOADER WITH A WORK ADD-ON
Danger
Risk of serious or fatal injuries when operating the loader!
Make sure there is no other person or living creature in the travel area.
Figure 24
Lowering the boom – push the control lever (3) forward.
Raising the boom – pull the control lever (3) backwards.
Tilting the bucket shut – push the control lever (3) left.
Tilting the bucket open – push the control lever (3) right.
Lowering the boom while at the same time tilting the bucket shut – push the control lever (3) forward and left.
Lowering the boom while at the same time tilting the bucket open – push the control lever (3) forward and right.
Raising the boom while at the same time tilting the bucket open – pull the control lever (3) backwards and right.
Raising the boom while at the same time tilting the bucket shut – pull the control lever (3) backwards and right.
13. CONTROLLING LOADER WITH AN AUXILIARY HYDRAULIC DEVICE
Danger
Risk of serious or fatal injuries when operating the loader and its attachments!
Make sure there is no other person or living creature in the travel area.
Figure 25
Figure 26
Some attachments require a connection to a hydraulic power and flow source in order to function. The connection to the
loader is through quick couplings, which are located on the arm of the boom. These are marked as F1 and F2.
Before connecting an attachment, check the technical condition and technical specifications.
Always wear protective gloves and goggles when connecting and disconnecting, as the hydraulic oil and quick couplings
may be as hot as 90 °C – risk of burns.
Do not connect damaged or technically incompatible attachments as they may cause serious damage to the loader and
other property, or pose a hazard to life.
Clean the quick couplings after use and put on the protective covers.
The attachment is controlled by switch (4). You can change the hydraulic flow volume by a combination of buttons (5),
(6) and (7) as follows: press and hold button (5) while simultaneously pressing and holding button (6) or (7). If you need
to increase the flow, hold down button (6). If you need to reduce the flow, hold down button (7) until the flow changes.
!
Caution
When working with an attachment fitted, follow the operating instructions supplied with each
attachment!
14. REMOTE CONTROL MINIZ 400
To turn on the remote control:
1.
Pull the red button (9) (main switch) up. When the green rectangular lights light up continuously, the loader controls
are active and the loader can work.
2.
Turn the ignition switch (11) to position I and press the button (11) on the side. When the green rectangular lights light
up continuously, the loader controls are active and the loader can work.
Figure 27
Danger
Caution: before activating the remote control, make absolutely sure that there are no people
or objects around the machine that could be injured or damaged. The minimum distance from
living creatures for operating the machine when using the remote control is 5 m.
35
Publicité
