First Green Industries MiniZ400 Instructions D'utilisation Et D'entretien page 17

DISTILLED WATER TANK
Install the container to a height of approx. 2.5 m.
After recharging the battery, top up the battery cells with distilled water. (Figure 21)
When the battery is charged, it must be replenished with distilled water. The distilled water tank is equipped with a water
valve, a propeller regulating the water flow and a quick coupling for connecting the battery. The valve on the distilled
water tank must only be released for as long as the flow meter indicates water flow. When the flow meter stops, close the
valve to prevent overflow from the cells. When the battery cells are replenished with water, disconnect the quick coupler.
Figure 19 Figure 20
!
Caution
The charger must be located in a covered area and sheltered from rain, snow and weather.
32
10.3 CHECKING THE CONDITION OF TRACKS
Danger
Risk of accidents! If a track is incorrectly tensioned, there is a risk of it coming off. The braking
distance extends and there is also a risk of the vehicle tipping over. Replace worn or damaged
tracks immediately.
If you want to use the loader with different types of tracks from those approved by the loader manufacturer, or with tracks
from another manufacturer, you must first obtain consent from the loader manufacturer.
Caution
!
Only track types approved by the manufacturer may be used.
Check tracks for wear and damage!
The tracks must not be damaged or worn.
10.4 ENTERING AND EXITING THE LOADER
Danger
When getting onto and off the loader, there is a risk of injury as a result of slipping, hitting parts
of the loader or getting stuck!
If the surface of the footwell is very dirty or greasy because of oil, there is a risk of slipping. There
is a risk of hitting your head on the machine frame when getting off the loader.
$ Make sure that the surface of the footwell is not slippery.
$ Do not jump onto and off the loader.
$ Make sure you always hold on firmly to the loader.
$ Do not wear jewellery at work.
$ Do not wear loose work clothing.
Danger
There is a risk of injury if you jump off the loader! If your clothing or jewellery (such as watches,
rings, etc.) gets caught in any part of the loader while jumping off the vehicle, you may suffer a
serious injury. It is forbidden to jump off the loader!
!
Caution
For getting onto and off the loader, only use equipment designated for this purpose. Improper
use can damage the machine components! Loader components such as the control levers, etc.,
are not intended as aids for getting onto and off the loader and may be damaged by improper
use.
10.5 SWITCHING ON THE IGNITION AND PUTTING THE LOADER INTO OPERATION
Caution
! Before switching on the ignition, all the pre-commissioning checks and actions must be carried
out with no fault as a result.
If you find a fault, do not use the loader and contact an authorized service centre.
Prior to putting the loader into operation and during operation, make sure that the bonnet is
properly closed and secured against opening. Otherwise there is a risk of damage to the loader
and its parts and a risk of injury.
Figure 21
1. Insert the ignition key into the ignition switch and turn it to the position "I".
2. The display will show information about the operating hours and the current battery status.
3. When the remote control is turned on, the green lamp lights up.
10.6 CHANGING THE FLOW RATE OF HYDRAULIC OIL
If the loader has an attachment connected that needs a hydraulic connection, you can change the hydraulic oil flow rate
within a range from 0 to 20 l. This change can be made by a combination of buttons (5), (6) and (7) as follows: press and
hold button (5) and increase the flow continuously by simultaneously pressing and holding button (6). Press and hold the
button (7) to reduce the flow continuously.
Figure 22
10.7 WORK LIGHTS
The loader is not equipped with work lights.
Caution
!
It is forbidden to operate the loader in conditions of reduced visibility!
10.8 ROAD LIGHTS
The loader is not equipped with road lights.
Caution
!
It is prohibited to drive the loader on public roads. The loader is not equipped for driving on
public roads. Do not drive the loader on public roads so as to prevent possible collisions or
impact-induced damage.
10.9 BEACON
The loader is not equipped with a light beacon.
33