First Green Industries MiniZ400 Instructions D'utilisation Et D'entretien page 14

Figure 7: Quick clamp in secured position
1 locking lever
2 retractable clamping pin
3 fixed clamping pins
Danger
Improper clamping of the work tool may cause injury or death. When the work tool touches the
ground, it may shift away from the clamp. Make sure that the work tool does not touch the ground
until the clamping pins are fully inserted.
Danger
By releasing the clamping pins of the mechanism, the technician loses control over the work tool.
Disconnecting the work tool when in an unstable position or when carrying a load can result in a
serious or fatal injury. Place the work tool in a safe position before releasing the clamping pins.
7.7 ELECTRICAL INSTALLATIONS
The electric drive of the loader is provided with a voltage of 48 V; some appliances are in the 12 V version. The power
source is batteries located in the rear part of the frame. The display operating unit, which is installed in the frame of the
machine, is used to check the operating data. The machine is controlled by means of the remote control. The remote
control compartment is in the rear part of the machine.
7.8 TREADING PLATFORM
The treading platform is used for occasional transport of the operating personnel of the machine when moving with the
loader from its parking place to the place of work. It is forbidden to stand on the treading platform while working with the
machine.
!
Caution
During service where the boom needs to be raised, the boom must be supported by a safety
strut.
26
8. VIEWS
8.1 OUTSIDE VIEW OF THE LOADER
Figure 8
Track chassis
1
Frame
2
Boom
3
4 Bonnet
5 Basic shovel
6 Remote control
7 Platform
Bucket cylinder
8
Boom cylinder
9
8.2 OVERVIEW OF THE DRIVER'S PLACE
Figure 9
Remote control
1
2 Holding bar for operator
3 Remote control holder
4 Operator's platform
8.3 OVERVIEW OF REMOTE CONTROL
Figure 10
Left control lever
1
2 Label with control indications
3 Right control lever
4 Attachment button f1, f2
5 Setting button
6 Setting button
Setting button
7
8 Speed switch
9 Stop button
10 Remote control connection indicator
11 Battery status indicator
On/off switch
12
Battery replacement
13
27