Changing Oil In The Hydrostatic Gearbox; Machine Lids And Casing; Cleaning And Washing - Eurosystems P130 Mode D'emploi

ferently, you should change the engine
oil after every fifty hours of use).
INFORMATION:
To facilitate the removal of the lubricat-
ing oil use the funnel in the accessories
envelope as shown in
6.6. CHANGING OIL IN THE
HYDROSTATIC GEARBOX
The fluids used in the hydrostatic trans-
mission have been carefully selected and
tested. Every product that is the equiva-
lent or greater than those indicated can be
used as an alternative.
INFORMATION:
Even though no oil change is specified
for the correct functioning of the ma-
chine a change after the first fifty duty
hours in order to eliminate any impuri-
ties created during the running in. Con-
tact your area dealer!
6.7. MACHINE LIDS AND CASINGS
Before the engine is started each time
check that the lids and casings, tools and
accessories are fitted properly and are in
tip top condition.
[ fig. 37 ] .
DANGER!
Replace damaged guards before using
the machine!

6.8. CLEANING AND WASHING

Cleaning:
1. Turn off the machine and wait for all
the moving parts to stop;
2. Remove the ignition key and/or the
spark plug hood.
3. Wait for the hot parts of the machine
to cool down adequately (at least 15-
20 minutes).
4. Blow compressed air into the slots
indicated in [ fig. 40 ]
the front and rear of the machine.
CARE!
Under no circumstances remove the
protection lids on the machine.
Washing:
1. Turn off the machine and wait for all
the moving parts to stop;
2. Remove the ignition key and/or the
spark plug hood;
3. Wait for the hot parts of the machine
to cool down adequately (at least 15-
20 minutes);
4. Wash the machine using a sponge
with neutral detergent and water. Avoid
arranged at both
EN-35