Engine Tilting Kit; First Battery Connection - Eurosystems P130 Mode D'emploi

5.2.5. ENGINE TILTING KIT (OPTIONAL)
It is sold as an option on the electrically
starting versions it permits the automatic
side inclination of the engine by approx-
imately 20° each side as shown in
30 ] .
Usable with iron wheels and wideners to
work on slopes above 20° up to a maxi-
mum of 45°.
Up to approximately 20° the engine au-
tomatically stays upright. Over 20° it
remains inclined downwards as shown
in [ fig. 30] .
CARE!
The holes shown in
free. Do not insert screws or other ob-
jects.
DANGER!
When working on slopes over 20° al-
ways use iron wheels with wideners
as required in the paragraph "Work on
slopes specifications".
INFORMATION:
When the machine is turned off, the
engine remains in the position it is. On
turning the ignition key [21] to "RUN the
machine will straighten up to vertical
[ fig.
[ fig. 31 ] must stay
after some seconds (if the slope is less
than 20°).
INFORMATION:
After a change in slope, it is normal for
the engine to take a few seconds before
it is fully vertical.
5.2.6. LED TELL-TAIL LIGHT (OPTIONAL)
The LED tell-tale light [31] in the version
with electrical starting with engine tilting
kit, it indicates:
Fixed ignition:
Engine oil pressure too low Rapidly re-
duce the working slope and/or check the
engine oil level.
Intermittent ignition:
For ten seconds after the ignition: initiali-
sation of the control board;
During the work: when the maximum slope
is exceeded reduce the work slope quick-
ly.

5.3. FIRST BATTERY CONNECTION

(OPTIONAL)
Before starting the machine equipped with
electric starter you need to connect the
EN-25