Use - Eurosystems P130 Mode D'emploi

CARE!
Do not hold the key in the START posi-
tion for very long and release it as soon
as the machine starts. Do not move it
to the START position again while the
machine is on.
7. Once the engine has started, move
the accelerator lever [20] to an inter-
mediate position and let the motor
warm up (5-10 minutes) before posi-
tioning it at the point of top speed and
beginning work.

5.8. USE

DANGER!
Always pay particular attention when
the PTO is engaged.
DANGER!
Always use the personal protection de-
vices required in the paragraph "Cloth-
ing".
DANGER!
Never leave the work operating posi-
tion behind the handlebars when the
machine is working. Never leave the
machine unguarded with the engine
running.
EN-28
DANGER!
Do not adjust the handlebar when the
machine is moving.
DANGER!
Be careful of the hot parts of the ma-
chine like for example the muffler and
the muffler protection.
DANGER!
If the machine and/or the accessories
should get clogged up, turn off the en-
gine and remove the ignition key and/or
the spark plug hood before intervening.
DANGER!
If the tool, the accessory or the ma-
chine gets damaged, immediately turn
off the engine.
Procedure:
1. Turn on the engine as described in
the "Turning on the Engine" chapter;
2. Before beginning to work, adjust the
handlebars to the preferred position or
the position most suitable for the type
of work to be done;
3. Set the forward motion limit speed
by adjusting the speed limit lever [30];
4. Press the dead man's lever [24] and
keep it pressed;
5. To move forward or backwards use
the levers [27] or [28];