Forward, Reverse And Speed; Power Assisted Stearing; (Pas) - Eurosystems P130 Mode D'emploi

DANGER!
In dangerous situations release the
dead man's brake [24] immediately.

5.1.3 FORWARD, REVERSE AND SPEED

LIMITING LEVER
INFORMATION:
In order to be able to use the forward
levers [28] and reverse levers [27] it is
necessary to keep the dead man's lever
[24] pressed.
Forward movement:
Gradually pull one or more of the for-
ward levers [28]
of the machine will vary in continuous
mode from a minimum of 0 km/h to
maximum defined by the position of
the speed limiting lever [30] shown
in [ fig. B ] .
Reverse:
To activate the reverse press the levers
[27] [ fig. 10c ] with the thumbs or with
the palm of the hand. The speed of the
machine will vary in continuous mode
from 0 km/h to approx. 3.5 km/h.
Speed limiting lever (only forwards):
By moving the speed limiting lever
[30] to a higher gear
[ fig. 10b ] . The speed
[ fig. 06 ] or lower
gear, the maximum speed of progress
that can reached will be increased or
decreased. The maximum speed in re-
verse gear will not be affected by the
position of the speed limiter lever.
Always use movement speed appropriate
for the work you are doing.
DANGER!
Do not tamper with and/or modify the
lever system in order to modify the
maximum and minimum forward and re-
verse speeds.
INFORMATION:
The machine's maximum and minimum
speeds can vary depending on the
tool mounted (weight, friction with the
ground etc.), and the type and condi-
tions of the ground.

5.1.4 POWER ASSISTED STEARING

(PAS)

INFORMATION:
In order to use the power assisted
steering system, it is necessary to keep
the dead man's lever [24] pressed.
By moving the handlebars [18] to the right
or left a difference will be produced in the
EN-19