VEVOR FLM-R30-FT Mode D'emploi page 454

End add points: it is used for YAG laser, will fix the light in the end. Software add the
points in the end of pen, but don't add the object.
Count: the count of points.
Distance: the distance between points.
Time per: each point's marking time.
Point cycles: each point's marking number.
Time per point: This parameter is used to set the marking time if there are dot objects.
Vector point mode/Pulse per point: Marking the vector graph using point mode, and force
the pulse number while marking each point
YAG optimize mode: While marking on the high reflection material using YAG laser,
optimize the hatch arithmetic. Note: the function is used to resolve the irregular lines when
marking on the high reflection material using YAG laser. If you want to use this function, you
must connect the PWM signal to the pulse modulate signal of the Q-switch.
Now let's take it into practice:
Mark a rectangle with size 40×20 and fill it with the following parameters: Mark Contour/
Edge offset=0 / Line Distance =1.0 /Hatch Angle= 0 / Unidirectional hatch
Set the marking parameters like this:
Parameter Name: XX----- the name users customize (easy to understand it's means.);
Loop count: 1;
Marking Speed: XX----- the speed users need;
Jump Speed: XXX----- the jump speed users customize (It is suggested to use 1200 –2500.);
Power Percentage: 50%;
Frequency: 5KHZ;
Start TC: 300;
End TC: 300;
Polygon TC: 100;
Jump Position TC: 1000;
Jump Distance TC: 1000;
End compensate: 0;
Acc. Distance: 0;
There may be several results to mark this hatched rectangle.
Case #1: The hatch-lines and the border are separated. (Figure 10-6) This is because the Start
TC Value is too big, and it needs to be smaller.
EzCad2UNI User's Manual
124
All rights reserved