2.1 Disclaimer
Your engraver may differ somewhat from those shown in this manual due to options, updates,
etc. Please contact us if your marking machine came with an outdated manual or if you have any
other questions.
2.2 General Safety Instructions
• Use this laser marking device only in accordance with all applicable local and national laws
and regulations.
• Use this device only in accordance with this instruction manual and the manual for the
engraving software included with it. Only allow this device to be installed, operated, maintained,
repaired, etc. by others who have also read and understood both manuals. Ensure that this manual
and the software manual are both included with this device if it is ever given or sold to a third party.
• DO NOT leave this device unattended during operation. Observe the device throughout
operation and, if anything seems to be operating strangely, immediately cut off ALL power to the
machine and contact either our customer service or your dedicated repair service. Similarly, ensure
the device is FULLY turned off in the correct order after each use.
• DO NOT allow minors, untrained personnel, or personnel suffering from physical or mental
impairment that would affect their ability to follow this manual and the software manual to install,
operate, maintain, or repair this device.
• Any untrained personnel who might be near the device while it is in operation MUST be
informed that it is dangerous and fully instructed on how to avoid injury during its use.
• Always keep a fire extinguisher, water hose, or other flame-retardant system nearby in case of
accidents. Ensure that the local fire department's phone number is clearly displayed nearby. In the
case of a fire, cut electrical power before dousing the flame. Familiarize yourself with the correct
range for your extinguisher before use. Take care not to use your extinguisher too close to the flame,
as its high pressure can produce blowback.
Safety Information
11