Character Properties - Vevor Flm-R30-Ft Mode D'emploi

Typing text directly in the work space is supported in EzCad2, and many types of fonts are
supported. To type text, users can select command "Text" in the
Draw Menu or click icon.
Under the command "Text", users can set up a starting point
at any position wanted in the work space to type characters by left
click mouse.

4.7.1 Character Properties

When selected, the Properties Toolbar will display a feature
like Figure 4-7 shows. Users may change the characters by typing
in the text box.
EzCad2 supports five types of text. (Figure 4-8)
When users select a type, a font list under that type will
appear to show all the available fonts. Figure 4-9 is the list of
TrueType.
Figure 4-10 is the list of Barcode Type.
Height: the average height of characters
: Figure 4-11 shows the dialog box after clicking
this icon.
: When selected, the current text aligns left.
: When selected, the current text aligns
center.
: When selected, the current text aligns
right.
Bold: When selected, the current text become
bold.
Italic: When selected, the current text become
italic.
Enable the same width character: make the
width of all characters the same
Char Width: the average width of characters
Char Angle: the degrees the characters incline
Char space: the distance between characters
Lines space: the distance between rows
Empty char width: the width of empty char
4-7 Character Properties
Figure 4-8 Types of Text
Figure 4-9 TrueTpye List
30